Repair Kit for Homefixitparts Number P2-04-210 Washer and seals Includes detailed instruction sheet
Step 1 : Turn Off Water.
Step 2: Flush Toilet to remove water.
Step 3: Lift Lid Lester says "Use a sponge or towel to remove any water from the bottom of the tank"
Step 4: Remove the supply nut from the bottom of the toilet ballcock unit.
Step 5: Remove the Ballcock Jamb nut from the ballcock.
Step 6: Pull the old ballcock out from the top of the tank.
Step 7: Push the new ballcock shank washer over the bottom thread of the ballcock.
Step 8: Insert the new Ballcock through the hole from the top inside of the tank.
Step 9: Screw the ballcock nut from below the tank. Lester says "Make sure the float arm is in the correct postion"
Step 10: Secure the jamb nut until tight use adjustable wrench or pliers
Step 11: Attach the float and float rod if applicable and refill tube.
Step 12: Reconnect the supply line to the ballcock
Step 13: Turn on water and always check for leaks. Lester says "check the angle stop valve later as they tend to leak after they have been turned off"
Step 14: Flush toilet check for water spraying in the tank.