SANIBEL BATHROOM FAUCET LEAD FREE BRUSHED NICKEL Ceramic disc cartridge Metal lever handle Optional cover plate Less pop-up LEAD FREE

Installation Instructions

Step 1 Remove old faucet from sink and clean surface sink. 
Step 2 Remove your Faucet from box and verify all parts for installation are available. 
Step 3 Place the faucet from the top through the holes in the sink. 
Step 4 Make sure that the faucet fits firmly and squarely on the surface of the sink. "If the faucet will not sit flat on the sink the use of plumbers putty or a chalking compound may be needed to avoid water from leaking under the faucet. Be sure to make sure plumbers putty will not stain the surface." 
Step 5 Screw the faucet mounting lock nut onto the 1/2 IPS connections until both sides are tight Lester Says "do not over tighten". 
Step 6 If using flexible connectors simply attach the 1/2" female pipe nut to the bottom of the 1/2" IPS connections. Lester Says "Make sure that the hot water side attaches to the left side of the faucet and the cold to the right." 
Step 7 Tighten the connector with wrench until tight "do not over tighten". 
Step 6 If using flexible copper slide the nut over the copper tube then slide the cone washer over the tube with the flat side down. 
Step 7 Attach the tube nut to the 1/2" IPS connections. Lester Says"Make sure that the hot water side attaches to the left side of the faucet and the cold to the right." 
Step 8 Use a wrench and tighten the nuts. 
Step 9 Remove the aerator and turn the water on, after checking for leaks below allow water to fully flush the faucet and reinstall the aerator Lester Says"check for leaks again". 
Use the drawings below to help you with your installation: